優道缸內積碳清洗劑

品牌：優道 

產品編號：UD-246

企業標注編碼：Q/YKJH 42

產品僅供4S店使用

產品性能

1、有效清洗燃燒室、活塞、活塞環槽等部件上的積碳、附著物；

2、快速釋放卡死在活塞環槽中的活塞環，恢復活塞環的彈性及運動性；

3、降低機油的消耗量，降低發動機的工作噪音，降低有害氣體的排放；

4、均衡氣缸壓力、提升動力、節省燃油。

使用方法

1、預熱發動機到正常溫度；

2、依次拆下各氣缸火花塞；

3、每缸注入一支清洗劑，靜置30分鐘；

4、裝上火花塞，恢復所有部件；

5、啟動發動機怠速運轉1分鐘；

6、然后踩油門至2000-3000轉運轉，以便已經軟化的積碳徹底排出，直至尾氣煙霧排盡（約2-3分鐘）。

注意事項

1、請避免將本產品掉在汽車漆面上；

2、本產品對三元催化器、氧傳感器、橡膠制品及密封件無不良影響；

3、使用該產品后，無需更換潤滑油。

Product performance

1. Effectively clean carbon deposits and attachments on combustion chamber, piston, piston ring groove and other parts;

2. Quickly release the piston ring stuck in the piston ring groove to restore the elasticity and mobility of the piston ring;

3. Reduce the consumption of engine oil, the working noise of engine and the emission of harmful gases;

4. Balance cylinder pressure, improve power and save fuel.

Usage 

1. Preheat the engine to normal temperature;

2. Remove the spark plugs of each cylinder in turn;

3. Inject one detergent into each cylinder and leave it for 30 minutes;

4. Install spark plug and recover all parts;

5. Start the engine to idle for 1 minute;

6. Then step on the accelerator to 2000-3000 for transfer, so that the softened carbon deposit can be completely discharged until the exhaust smoke is exhausted (about 2-3 minutes).

Note

1. Please avoid dropping the product on the car paint;

2. The product has no adverse effect on the three-way catalytic converter, oxygen sensor, rubber products and seals;

3. After using the product, there is no need to change the lubricating oil.