品牌：施立盾

系統：全車防銹

快干防銹彈性膠

產品編號：S.02.021 480ML

企業標準：Q/YKJH 6

僅供4S店使用

產品性能:

1、保護車底金屬與水隔離，避免生銹

2、堵塞部件聯接縫隙，緊扣螺絲避免行駛中脫落；

3、隔除車底噪音傳播，防止砂石撞擊損害；

4、提高車內行駛舒適感，延長車輛使用壽命

使用方法：

1.將車底需噴涂的部件徹底清潔，如有銹跡應鏟除、砂光，達到無塵，無水，無油，無蠟跡將不需噴涂的部位（排氣管、發動機、水箱、彈簧、空調冷凝器等）進行嚴密覆蓋。

2.充分搖動本品約2分鐘，打開灌蓋，去除封口，插入本廠專用噴槍，連接0.6-0.8Mpa壓縮空氣。在距離噴涂表面約25cm處，來回均勻噴涂。

3.為防止流痕和松垂，建議分三次噴涂。在第一次噴涂完成后，對孔洞，裂縫處使用車膩子填封、刮平；待前一次噴涂干燥后（不少于15分鐘）再進行噴涂。厚度達到1.5mm以上隔音效果明顯。

4.本品未干固前可用汽油清洗

注意事項：

眼睛接觸,請立即用大量的清水清洗,并立即就醫;

如果誤食,不要催吐,立即就醫,并出示該物品的盛裝容器或標簽。

Armored chassis (oily)

properties:

1, protect the car with water metal isolation, avoid rust

2 and plugging parts connected to the aperture, gripping screw avoid driving fall off;

3, the car in addition to the noise propagation, prevent sand crash damage;

4, improve in-car driving comfort, prolong the service life of the vehicle

Usage :

1. To spray parts of the car will thoroughly clean, if have should be razed and rust sanding, to clean, no water, no oil, no wax mark will need not spraying parts (the exhaust, engine, water tank, spring, air conditioner condenser, etc) closely covered. 

2. Fully moved this article about 2 minutes, open the irrigation cover, remove the seal and insert the factory special spray gun, connection-0.6 Mpa compressed air. In the distance spraying the surface of about 25 cm place, spray evenly back and forth.

3. To prevent flow mark and baggy, suggested in three spraying. In the first time after the completion of the spraying of hole, crack in car use, to blow be bored with child fill seal flat; For a time after dry before spraying (not less than 15 minutes) and then spraying. 1.5 mm thickness above sound insulation effect is obvious.

4. This product did not work to solid available before gasoline to clean

Note:

Avoiding Any Eye Contact ,if contact, please immediately with plenty of clean flowing water and seek medical advice immediately;

If swallowed, don't spits, seek medical advice immediately and show this container or label the dress items.